ems4.DE00F
System module 19“ for front installation
The ems4.DE00F system module is to be arranged in a 19” subrack. This module supplies power (24V DC system, 24 VDC emergency, CAN, LIN) to all other 19” modules. 5 freely configurable signals are available for display on the module. The signals are sent from the control unit to the ems 4.DE00F, where they are displayed via LEDs (red / green). The module also contains a Piezo signal generator which enables audible signalling, e.g. of a system malfunction. Two potential-free outputs (relay changers) allow an additional signal output for any remote display panels or for switching a consumer. These can either be switched on or off in a defined manner by the control unit, or an automatic on/off function (configurable frequency) can be implemented using the ems4.DE00F.
- Voltage:24 V DC +/- 10 %
- Power consumption:1 W
- Electrical connection:Via screw terminals for wires up to 2.5 mm²
- Mounting:19” rack
- Housing:Aluminium front panel with front film
- Dimensions:12HP x 3RU x 75 mm
- Weight:230 g
- Protection class:IP20 front, IP00 rear
- Operating temperature:+5...+45 °C
- Ambient humidity:Up to 85 % rh. without condensation acc. to VDE 0160, EN 50178, Class 3K3
- Standards / rules / guidelines / approvals:See EU Declaration of Conformity
- Inputs:1 x digital 24 V DC
- Outputs:
- 3 x push button switch, potential-free NO contact load 24 V, 30 mA
- 2 x potential-free changeover contact 24 V AC, 2.5 A ohmic load
- Transistor output for flashing cycle of all connected 19” modules with alarm inputs
- Piezo signal transmitter
- LED display:Via Duo LED
- System bus:CAN bus
- Interfaces:1 x LIN bus